Power Sag - Voltage below 80% to 85% of rated RMS voltage for one or more cycles.
RS232C (Recommended standard RS232C) - Standard defining the communication circuits between devices for synchronous and asynchronous transmissions on the following types of lines - two-wire, four-wire, point-to-point, telephone lines and local links with short cables. Though the standard covers only transmissions over distances up to 15 meters, it is often possible to ensure correct transmission over greater distances using high-quality shielded cable in a reasonably satisfactory electrical environment. Most terminals and devices on the market can implement this transmission standard.
E-Rate - Discharge or charge power, in watts, expressed as a multiple of the rated capacity of a cell or battery which is expressed in watt-hours. For example, the E/10 rate for a cell or battery rated at 17.3 watt-hours is 1.73 watts. (This is similar to the method for calculating C-Rate.)
Overcharge - The forcing of current through a cell after all the active material has been converted to the charged state, that is, continued charging after reaching 100 percent state-of-charge.
Inverter - UPS subassembly that recomposes a sine-wave output (regulated and without breaks) using the DC current supplied by the rectifier-charger or the battery. The primary elements of the inverter are the DC/AC converter, a regulation system and an output filter.
Distortion (total) - Ratio between the rms value of all harmonics of a non-sinusoidal alternating periodic value and that of the fundamental. This value may also be expressed as a function of the individual distortion of each harmonic Hn= Yn /Y1.
Current Collector - An inert structure of high electrical conductivity used to conduct current from or to an electrode during discharge or charge.
